CIPMUX
fuho edited this page
·
3 revisions
Pages 52
- Home
- AT
- AT IPR
- at_0019000902
- AT_Description
- at_example_0020000903
- ATE
- Basic example
- basic_at_0019000902
- Blinky
- Building
- chip internals
- CIFSR
- CIPAP
- CIPAPMAC
- CIPCLOSE
- CIPMODE
- CIPMUX
- CIPSEND
- CIPSERVER
- CIPSTA
- CIPSTAMAC
- CIPSTART
- CIPSTATUS
- CIPSTO
- CIUPDATE
- Compiler
- CWDHCP
- CWJAP
- CWLAP
- CWLIF
- CWMODE
- CWQAP
- CWSAP
- Drivers
- ESP8266 Memory Map
- Examples
- GMR
- gpio registers
- GSLP
- Hardware_ESP8266 Versions
- Hardware_versions
- info_dump
- IPD
- IPR
- Pin definition
- RST
- TCPIP_at_0019000902
- Toolchain
- Uploading
- W25Q40BVNIG
- wifi_at_0019000902
- Show 37 more pages…
- Home
- Compiler
-
AT Command set
-
Basic AT
> AT
> AT+RST
> AT+GMR
> AT+GSLP
> ATE
-
WIFI Function AT
> AT+CWMODE
> AT+CWJAP
> AT+CWLAP
> AT+CWQAP
> AT+CWSAP
> AT+CWLIF
> AT+CWDHCP
> AT+CIPSTAMAC
> AT+CIPAPMAC
> AT+CIPSTA
> AT+CIPAP
-
TCPIP Function AT
> AT+CIPSTATUS
> AT+CIPSTART
> AT+CIPSEND
> AT+CIPCLOSE
> AT+CIFSR
> AT+CIPMUX
> AT+CIPSERVER
> AT+CIPMODE
> AT+CIPSTO
> AT+CIUPDATE
> +IPD
> AT+IPR
-
Basic AT
- AT Command Test Example
Clone this wiki locally
AT+CIPMUX – Enable multiple connections or not
| Type | Instruction | Response | Function |
|---|---|---|---|
| Set | AT+CIPMUX=mode
|
OK | Set connection mode, single connection or multiple connection. |
Parameter description：
mode:
- 0: single connection
- 1: multiple connection
NOTE
This mode can only be changed after all connections are disconnected. If server is started, reboot is required.